familyname=Series 7 Boards
manufacturer=Digitrax
definitionSource=JMRI
LOCONETBD7OPSWMODECV=1,"Board Address"
CV=11,","","over-current","","auto-reverse","","light mode (8 outputs)"DS1 mode: "
CV=11,","","over-current","","auto-reverse","","light mode (8 outputs)"DS2 mode: "
CV=11,","","over-current","","auto-reverse","","light mode (8 outputs)"DS3 mode: "
CV=11,","","over-current","","auto-reverse","","light mode (8 outputs)"DS4 mode: "
CV=11,","","normal","","lower","","higher"Trip current: "
CV=12,","","enabled","","disabled"Occupancy detection: "
CV=12,","","enabled","","disabled"Transponding detection: "
CV=14,","","normal","","increased"Sensitivity: "
CV=16,","","detection","","relay state"LEDs show: "
LOCONETBD7OPSWMODEReset All CVsCVs<html>The "CV" column in the table above shows CV
                        numbers, not the Op Switch number.  To see those, hover
                        your mouse over a variable on the OpSw Settings pane.
                        <p><p>The top-most row above reflects the Board
                        Address configured on the "Basic" sheet.
                    Basic<html><p>
                <p>This roster entry will only access the specified
                board if the Board Address (i.e. Board ID), specified above,
                <br>was correctly entered when the roster entry was first created.
                You cannot change it here.
                <p>Note that some Digitrax documentation refers
                to Board Address, while other documentation refers to
                <p>Board ID.  These are equivalent concepts.
            </html>OpSw Settings