familyname=Series 7 Boards
manufacturer=Digitrax
definitionSource=JMRI
LOCONETBD7OPSWMODECV=1,"Board Address"
CV=11,","","pulse solenoid (4 outputs)","","slow motion (4 outputs)","","light mode (8 outputs)"Output type: "
CV=11,","","enabled","","disabled"Internal Routes are"
CV=12,","","disabled","","enabled"Bushby Bit is"
CV=12,","","do turnout, sensor commands","","trigger routes"Input Lines"
CV=12,","","Loconet switch commands","","DCC switch commands only"Command source is"
CV=12,","","echo to Loconet","","do not echo to Loconet"Route Switch Commands"
CV=13,","","normal","","high CD voltage"Solenoid Pulse"
LOCONETBD7OPSWMODEReset All CVsCVs<html>The "CV" column in the table above shows CV
                        numbers, not the Op Switch number.  To see those, hover
                        your mouse over a variable on the OpSw Settings pane.
                        <p><p>The top-most row above reflects the Board
                        Address configured on the "Basic" sheet.
                    Basic<html><p>
                <p>This roster entry will only access the specified
                board if the Board Address (i.e. Board ID), specified above,
                <br>was correctly entered when the roster entry was first created.
                You cannot change it here.
                <p>Note that some Digitrax documentation refers
                to Board Address, while other documentation refers to
                <p>Board ID.  These are equivalent concepts.
            </html>OpSw Settings