Some brief comments on Programming Modes
Address Mode is an outdated programming method that is included here for the sake of
full compliance with the NMRA DCC standard.
Register Mode is an expanded form of Address Mode, and is still used by some older and/or lower end decoders, particularly some from MRC and Wangrow. It is inherently limited in its ability to access all CVs in a decoder.
Paged Mode is an expansion of Register mode that gives full access to all decoder CVs.
Direct Mode is another method, not yet supported by all decoders, that allows full access. There are two ways of implementing Direct Mode. The radio button(s) for the Direct Mode method(s) your command station supports will be activated.
If you experience difficulty programming a decoder in Paged Mode, try Direct Mode, then
Register Mode, and finally Address Mode. The EasyDCC AD4 Accessory Decoder can only be
programmed in Direct Mode.