JMRI: Select DCS240 USB Mode

A Digitrax DCS240 USB interface can act either as a stand-alone programmer, or as an interface to a LocoNet, but it can only do one at a time. Normally, you choose the USB mode as part of setting the JMRI connection preferences.

In some cases, you might want to quickly change the mode during debugging. This tool provides two buttons to allow you to change the DCS240 USB mode immediately. Note that this may result in unusual (and usually bad) behavior from the program! It's generally better to switch mode by changing the JMRI preferences and restarting the program.

For more information on the DCS240, please see its JMRI reference page.