Package jmri.jmrix.rfid.protocol.olimex

This package holds objects specific to the RFID stand-alone readers that use an Olimex protocol.

As this protocol is uni-directional, the specific Reporters and Sensors incorporate a time-out technique as opposed to being explicitly de-activated.

Be sure to set the correct reader model in the connection profile. Current support is for the following readers which each uses a slightly different protocol:

Support for these readers assumes that the reader is in "CDC" mode. This reader mode is typically configured using a pushbutton on the reader.

Note that the console may show a pair of "Timeout" warnings from jmrix.AbstractMrTrafficController when the RFID device is initialized. This is expected behavior.

Since:
3.9.2, 4.7.5